Single Inverter System Export Limit Introduction: Single 1-Phase Inverter in 1-Phase supply​

1) Solution:

2) Model Mapping:

3) CT Installation​:

1. The CT is installed on the L wire of the main busbar.​

2. The CT comes with a line length of 10 meters, not recommended to extend. Otherwise, the accuracy will be affected.​

4) Connect CT to Inverter​:

1. Tight the waterproof nut and the communication interface cover, then connect the CT cable to the Com 2 port of the inverter, as shown in the figure.​

2. Twisting the S1 and S2 wires can effectively reduce the influence of electromagnetic interference.​

5) Setting​: